19mm + 32mm Cutting Discs with Arbor

Two pack of tough mild steel Perma-Grit cutting discs (19 & 32mm) with tungsten carbide welded to the edges. The discs will cut carbon fibre, fibreglass and all other composites with ease and will not 'fray' or shatter the edges of your precious material. In addition, these discs will not break or lose their edge, providing years of faithful service!

The discs are supplied with a 3mm arbor, locking washer and M3 nut.

Typical Uses

These Perma-Grit cutting wheels are perfect for trimming carbon fibre sheet, slot cutting (like for switch mounting in a carbon dash) and cutting through tough composites (like carbon/steel sandwich panels).

As with all Perma-Grit tools they are also able to cut stainless steel, spring steel, fibreglass, tile brick and more.

Further Information

How to Use

Use the Perma-Grit cutting discs with a variety of power tools sich as Minicraft, Dremel, Flexi-drives and similar small drills. Run at slow to medium speeds and wear eye protection at all times.

Trim lines can be then be rubbed smooth with a Perma-Grit sanding block or file (working from coarse to fine grit) and then finished with rubbing compound and wax.

Note: Regular use of electric drills (like those listed above) with carbon fibre will cause carbon dust to accumulate on your drill motor's electrical contacts and will eventually damage your drill. If possible, blow off your electrical tools after use with an air compressor and work in a well ventilated area to preserve the life of your electrical tools when working with carbon fibre.